On the TV2 remote hold sat until it stays lit, choose a number different than on the screen, touch pound (#), the sat light blinks three times, hit record, the number on the screen should change to match the one you typed in. Global Download Center for Satellite Receivers Firmware and Software Update Hivion Firmware. This is the address for each remote (tv1 and tv2). Showing different things but the remote still changes channels on both tvs? Go to TV1, hit menu twice, near the bottom there are two boxes each with a number. Still showing the same thing? check the back of the receiver, the RCA cables (red/white/yellow) are plugged into the TV1 ports not the TV2 ports. This website is all about satellite receiver softwares, a free resource where you can download softwares to update your satellite receiver or discuss your problems in the discussion forum.
make sure the modulation for tv2 matches which channel you put your tv2 on. Hivion Receiver Software Software Downloads.
If it is still showing the same thing, go to TV1 (the one with the receiver) and hit Menu, system setup, Installation, modulation (menu 6-1-5). Go to TV 2 (the one without the receiver) and make sure the TV is tuned to channel 60 or 73. If both TVs are still showing the same thing, then the issue is not the mode. Is the receiver in dual mode? Go to the receiver, open the door, and hit the mode key.
